GMSK DV node adapter


The node adapter is built around two major components. That is the GMSK modem chip (CMX589) and the controller (ATmega) that takes communication to the host (PC or Raspberry PI) for his account.

The modem supports D-Star hotspot and repeater functionality, half and full duplex so. The transceiver get connected to the present (mini DIN) 9600 bps packet connection.
 
- Fits on Arduino UNO and MEGA 1280/2560
- Standard mini Din /ps2 9600 packet connector
- half and full duplex mode support
- Complete assembled
- D-Star
 
Block diagram
 
Instructions
 
Step 1, Install USB driver for Arduino.

It is recommended to use for loading the firmware a standard Windows PC.
First you have to load the USB driver for the Arduino. Normally it will be recognized by Windows, in cases where it is not, I recommend to visit the following links:


Arduino website : http://arduino.cc/en/guide/windows
Youtube : http://www.youtube.com/watch?v=-epgmDX9Zfw
Step 2, Load the firmware.

Download and install Xloader. This is a simple program to load the firmware.

Download the hex file for your ARDUINO :

Start Xloader, choose the correct hex file, select Device and set the COM port to the port number that is assigned to the ARDUINO. The baud rate defaults to 115200. Then press Upload to load the firmware. If the firmware is loaded correctly a message will appear below in the bar of the Xloader screen.
 
Step 3, Settings G4KLX D-Star repeater software.

Installation manual DVMEGA GMSK shield
Mini Din info : Schematic
 



© 2013 PE1PLM, Guus van Dooren, dvmega@auria.nl

Creative Commons-Licentie